Bam mailist list remove how to#

In the automobile industry, many parts are manufactured this way (i.e. The material is then cooled to keep its new shape. Nevertheless, the manufacturing process is simple: the ABS sheet is softened and molded with heating panels and takes the contoured shape of the instrument. The cases that are made of ABS are thermoformed thanks to an hightech industrial material allowing constant regularity and quality in the finish. Scratches and friction on the shell are therefore also reduced To ensure optimum security, we recommend to place the hook with the screw facing out. Without secure tightening, this system would not be any better than a regular hook. Make sure to check the locks regularly and tighten them as needed before using the case. Their security screw system is extremely secure only if the locks are completely tightened before using them, as a hiker would do before climbing. These hooks have been developed by a manufacturer of mountain climbing equipment especially to answer our demand.

Then open and close the latch a few times to work the lubricant through the mechanism and the latch will be easier to use. These latches are the best in quality and longevity, but need a little care to maintain easy use: When they seem to be a little difficult to open and close, a drop of oil or a silicone-based lubricant will help. The inside mechanism of the latch is a compression spring system.

Bam mailist list remove how to#

HOW TO EXTEND THE LIFE OF A SOFT-TOUCH LATCH broken or missing teeth : change of the whole cover in our workshop no missing or broken teeth : Change of the zipper pulls in our workshop Use light pressure a few times until the slider is tight enough to slide along the zipper and properly close the teeth. Be careful not to apply too much pressure at first. Make sure to apply the most pressure to the back of the slider. Lightly clamp the pliers along the side of the slider and press down.

Open the zipper all the way before starting so the slider is touching the material of the cover. To stop this problem, you can tighten the back of the slider with a set of pliers. This is usually the first sign of a worn zipper and you should adjust it as soon as possible to avoid further problems. Therefore, you should not pull upward on the slider because it will loosen its jaws and eventually make the slider too loose to close the zipper properly. The slider is designed to slide back and forth along the zipper. Be sure that the zipper is completely unzipped before opening the case to prevent damage to the teeth. Make sure to leave your case open a few hours after this process to evaporate completely the stain remover.ДЄ zipper slider is made to open and close the teeth of the zipper. Humidify a cloth with a little bit of stain remover lotion/spray and gently rub the stain with it.

Gently apply a car scratch remover with a soft cloth GET RID OF THE SCRATCHES ON A HIGHTECH CASE Swipe your case with a microfiber cloth and a soft window-cleaner spray.